Water Based Metal Paint Single Component Quick Drying Epoxy Fura
This product is one-component epoxy modified furan resin coating,
which consists of epoxy modified furan resin as basic material,
antirust pigments, fillers, additives, solvent, etc. Drying fast
and well corrosive resistance.
It can be applied to anti rusty or bottom coating for metal
components, mechinery equipment, different kinds of vehicle.
Iron red or customized
Solid content in volume
Standard film thickness
Dry film: 40μm / Wet film: 89μm
12 ㎡/kg (Base on 30μm dry film)
Surface dry:≤30 minutes / Hard dry:≤18 hours
Substrate treatment: Removing dust, grease, water and other debris on the surface.
Steel surface is adopted sand-blasting with Sa2.5 degree rust
removal. For the segment butt joints and unattainable position for
sand-blasting, it is adopted power tools to mechanical polishing
rust removal with St3 degree.
Coating accessory: Epoxy polyamide intermediate paint, Epoxy polyamide finishing
coat, Polyurethane finishing coat, Chlorinated rubber finishing
AB313T Paint thinner
Brush coating / Roller coating
Chlorinated rubber paint,
Tools cleaning: All tools after use need cleaning with AB313T thinner.
Safety: Be careful to use this product. Please note the safety precautions
on the package label before or when to use it. In addition, you
should comply with the safety regulations of the state or local
government. Personal protection, including but it’s not limited to
lung, eye and skin. To see a doctor if swallowing or other direct
contact with this product. Precautions must be taken: fire
prevention, explosion prevention and environmental protection. The
construction of this product should only be in a well-ventilated
case. Powerful ventilation must be provided when applying paint in
a narrow place or stagnant air.
-Construction temperature is 5~40 ℃.
-Air relative humidity is less than 80%.
-The substrate surface humidity is 3 ℃ higher than the dew point.
-Avoid construction in the rain, snow, fog weather.
-Before coating the next paint, oil, condensate water, Welding
splash drops and dust should be cleaned up on the surface of
-Recoat interval is related to the environment. If maximum recoat
interval is exceeded, the surface have to be roughened to ensure
the adhesion between layers.
-Paint should be stored at low temperature, dry and ventilated
indoor warehouse. Keep away from heat and avoid direct sunlight.
-Construction workers should be required to wear labor protective
gear. Construction site and storage should be equipped with
fire-fighting equipment. To avoid fire, fire and smoking is
-This product is only suitable for professional use.